Sanyo LNS-W01Z Manuel d'utilisateur télécharger pdf

LCD PROJECTOR LENS

MODEL NO. LNS-W01Z / LNS-T01Z

LENS REPLACEMENT

AND INSTALLATION PROCEDURES

NOTES ON REPLACEMENT AND INSTALLATION

The procedures and the needed pars for lens installation depend on the type of

cabinet. Before installing or replacing the lens, make sure the type of cabinet and be

sure to refer to the Installation Manual corresponding with your projector.

When installing or replacing the lens, make sure the Lens Model No. matches with

your projector. Refer to the catalog, or contact your sales dealer for the proper Lens

Model No.

TYPE OF THE CABINET AND REFERENCE INSTALLATION MANUAL

Refer to the Installation Manual corresponding to your projector.

(See the chart below.)

Type of the Cabinet Reference Installation Manual

Refer to this manual.

Refer to the Installation Manual

supplied with the Projector.

Other than the above cabinet

design.

1 2 3 4

Résumé du contenu

Page 1 - AND INSTALLATION PROCEDURES

LCD PROJECTOR LENSMODEL NO. LNS-W01Z / LNS-T01ZLENS REPLACEMENT AND INSTALLATION PROCEDURESNOTES ON REPLACEMENT AND INSTALLATIONThe procedures and the

Page 2 - NOTES ON LENS INSTALLATION

Some parts are not used for installation or replacement. Keep these parts for later use.Note : Figures in this manual may be differ from the actual p

Page 3 - Set the light-block

LENS REPLACEMENT AND INSTALLATION PROCEDURE1. Remove screws A (2 screws).2. Pull down the lower lens cover while pushingthe part D, then remove it.3.

Page 4

MOUNT THE LENS COVER. (See figure-6)INSTALL THE LENS. (See figure-4)1. Remove protective caps(front andback) on the lens.2. Mount the lens on mounting