Sanyo CL2432 Manuel d'utilisateur

ContentsPageIMPORTANT!Please Read Before Starting... 11. GENERAL...

93-8. Wiring Instructions for Inter-unit Connections(1) Insert the inter-unit wiring (according to local codes)into the through-the-wall PVC pipe. Ru

10When connecting each power wire to the correspondingterminal, follow the instructions “How to connect wiring tothe terminal” and fasten the wire sec

113-9. Mounting Right-side tubing(1) Shape the refrigerant tubing so that it can easily gointo the wall hole. (Fig. 24)(2) Push the wiring, refriger

123-10. Drain Hosea) The drain hose should be slanted downward to theoutdoors. (Fig. 28)b) Never form a trap in the course of the hose.c) If the drai

134. Refrigerant Tubing4-1. Indoor Unit Tubing Rear-left tubingFor rear-left tubing, optional tube connection (C) (APR-EN46U1B) is necessary. Plea

144-3. Connecting Tubing between Indoor andOutdoor Unitsa) Tightly connect the indoor side refrigerant tubingextended from the wall with the outdoor

(2) Wrap the armoring tape from the bottom of the out-door unit to the top of the tubing where it enters thewall. As you wrap the tubing, overlap half

165. Remote Control Unit Installation PositionThe remote control unit can be operated from either anon-fixed position or a wall-mounted position.To e

1IMPORTANT! Please Read Before StartingThis air conditioning system meets strict safety and operat-ing standards. As the installer or service person,

21. GeneralThis booklet briefly outlines where and how to install theair conditioning system. Please read over the entire setof instructions for the

31-6. Additional Materials Required for Installation1. Refrigeration (armored) tape2. Insulated staples or clamps for connecting wire(See local codes

42-2. Outdoor UnitAVOID:● heat sources, exhaust fans, etc. (Fig. 4a)● damp, humid or uneven locations.DO:● choose a place as cool as possible.● choos

5IndoorsideOutdoorsideSet screws for transportation onlyRight-reartubing(recommended)Right tubingLeft-rear tublingFig. 6Fig. 7aCenter ofleft-reartubin

63-3. Install the Rear Panel on the WallBe sure to confirm that the wall is strong enough to sus-pend the unit.See either Item a) or b) below dependi

7How to replace the grille(1) Close the flaps.(2) Reinstall the grille into the lower part while aligningits tabs on the upper part. (Fig. 15a) Insert

83-7. Recommended Wire Length and DiameterRegulations on wiring diameter differ from locality tolocality. For field wiring requirements, please refer