Sanyo LNS-S03 Manuel d'utilisateur

Type of the Cabinet (1) See Page 2LCD PROJECTOR LENSMODEL NO. LNS-S03LENS REPLACEMENT AND INSTALLATION PROCEDURESNOTES ON REPLACEMENT AND INSTALLATION

-9-7Replace Lower Lens Cover. Slide Light-Block Sheets into the guide of Lower Lens Cover and setthem in front of the flap. (See Fig. 7.) Fix Lower L

Some parts are not used for installation or replacement. Keep these parts for later use.Note : Figures in this manual may be differ from the actual p

LENS REPLACEMENT AND INSTALLATION PROCEDURE{Type (1) Cabinet}-2-1Remove Lower Lens Cover. Remove 2 Screws A.Push part B and pull Lower Lens Cover down

5Connect Lens Motor Lead to the connector"K96T" on the circuit board under the lens.4Replace Lens Cap on the rear (mounting side) of Project

Fig-6LIGHT BLOCK SHEETMake sure the sheet figure and puton proper position.-4-6Use a Light-Block Sheet (provided with projector) corresponding with le

-5-7Replace Upper Lens Cover. Slide Light-Block Sheet into the guide of Upper Lens Cover and setthem in front of the flap. (See Fig. 7.) Fix Upper Le

LENS REPLACEMENT AND INSTALLATION PROCEDURE{Type (2) Cabinet}-6-1Remove Lens Cover. Remove 2 Screws A. Pushpart B and pull Upper Lens Cover up. (See F

-7-5Connect Lens Motor Lead to the connector"K96T" on the circuit board under the lens. FixLens Motor Lead with the lead holder on the cir-c

6Use 2 Light-Block Sheets (provided with projector) corresponding with lens. (Refer to the Type No.below.) Set 2 Light-Block Sheets through the lens.M