Sanyo POA-MD13NET2 Manuel d'utilisateur Page 84
- Page / 92
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
84
Chapter 7 Appendix
Q&A
Why doesn’t the setting page appear in my web browser?
Following causes are possible. Please check them.
1. The projector is not connected to the network.
Check LED indicators status (☞ p.13).
- Check the connection of LAN cable if the LINK indicator does not illuminate
orange.
- Check the network configuration of the projector if ACT indicator does not
illuminate green.
2. Function “Network” in the projector is not set to“ON”.
Set up by using the projector’s on-screen menu (☞ p.16, 20).
3. Wrong network configuration of the projector
Check the network configuration of the projector by using the projector’s on-
screen menu (☞ p.16, 20).
4. Wrong network configuration of the computer.
Check the network configuration of the computer.
5. The Network Board is used with the default setting (☞ p.16, 20).
6. The proxy setting of the web browser is not set correctly (☞ p.72).
7. The computer does not provide TCP/IP protocol.
No setting page in my web browser? Is the problem in the network or
in the projector? I would like to find out the problem whether it is in
the network or in the projector
Check it by the following steps
1. Disconnect the projector from the network and connect the projector and
computer with the UTP cross cable directly.
2. Change network configuration of the computer and projector as shown in the
example below.
(Computer setting)
IP Address : 192.168.0.5
Subnet Mask : 255.255.255.0
Default gateway : (blank)
DNS : (blank)
(Projector setting)
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default gateway : 0.0.0.0
DNS : 0.0.0.0
A
Q
A
Q
Installation/Access
- POA-MD13NET2 1
- Compliance 2
- Contents 3
- Chapter 1 5
- Preparation 5
- Features 6
- Internet 7
- Intranet 7
- Operating Environment 8
- Computer 9
- The limitation* 9
- Expression/Abbreviation 10
- Use of this manual 10
- Trademark 10
- Chapter 2 11
- Installation 11
- Flow of installation 12
- Caution 13
- 2 Remove 2 screws on a board 14
- 1 Turn the Mains switch off 14
- (10Base-T, 100Base-TX) 15
- UTP straight cable 15
- Projector 15
- Mains Switch 15
- 1 Selection of network menu 16
- 3 Restart the Network board 17
- Network PIN code setting 18
- 10-key pallet 19
- Network configuration (Type2) 20
- Password 22
- Network Board 23
- Chapter 2 Installation 24
- Chapter 3 25
- Basic Setting and Operation 25
- 1 Enter the IP address 26
- Display of main setting page 27
- Initial Settings 29
- 2 Password Setting 30
- 3 Date/Time Setting 30
- Network Configuration 31
- E-mail Setting 32
- E-Mail Setting 33
- Chapter 4 35
- Controlling the Projector 35
- Power on/off the projector 36
- Check the status of projector 37
- Control the projector 38
- PC Adjustment 39
- Load a Set 40
- Save a Set 40
- System Adjustment 41
- Image Adjustment 42
- Save a image adjustment value 43
- Load a image mode 43
- Sound Adjustment 44
- Screen Adjustment 44
- Control the Projector 45
- About Lamp Counter reset 46
- 1 Set a day or date 48
- 2 Set a time 48
- 4 Register an event 48
- Getting the current time 49
- Cancel the timer 49
- 1 Adjust and set the controls 51
- 2 Select the Save page 51
- 3 Name the current setting 51
- 4 Save the current setting 51
- Load a control set 52
- Control the projector’s menu 53
- Make a memo 54
- Chapter 5 55
- Multi-Control 56
- OWNER’S MANUAL 57
- IP address 57
- Projector name 57
- Chapter 6 61
- Use of Serial Port 61
- Serial Port setting 62
- RS-232C serial cable 64
- Use of Telnet 66
- Chapter 6 Use of Serial Port 68
- * Use the IP address 68
- Command list table 68
- Chapter 7 69
- Appendix:A 69
- Examples of Connection 70
- Examples of connection 71
- To another network 71
- Web browser setting 72
- Examples: OS/Browsers 73
- Proxy setting 74
- Netscape Navigator v.7.0 75
- JavaScript Setting 75
- Mac OS 8.6 77
- Netscape Navigator v.4.7 79
- Product specification 81
- Port Specification 82
- Appendix:B 83
- Installation/Access 84
- Chapter 7 Appendix 86
- IDRMD (built in KJ5AL) (b) 92
Produits connexes et manuels pour Projecteurs Sanyo POA-MD13NET2
Projecteurs Sanyo 12BL Manuel d'utilisateur
(56 pages)
(56 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.078 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels