Sanyo PDG-DET100L Manuel du propriétaire télécharger pdf (Page 22)

Installation

Attaching the Cable Cover

Fix the opposite end of the strap to the hole inside the

support cover with a screw (supplied).

Insert the support cover into the cover insertion slot and

slide it to the left.

Tie a strap (supplied) to the lower bracket on the right side

of the projector’s terminal area. (See the right figure.)

Dress and secure all cables to a cable tie (supplied). The

cable tie is reusable and can be opened and closed as

many times as needed.

Tie another strap (supplied) to the upper bracket on the

right side of the projector’s terminal area.

Fix the opposite end of the strap to the hole inside the

cover with a screw (supplied).

✔Note:

• Attach the support cover first, otherwise the cover cannot

be fixed properly.

Strap

Support

Cover

Screw

Cable tie

Cover

Strap

Screw

Cover

insertion slot

To attach the cover, insert the rods inside the cover into

the holes on the side cover until it clicks. (See the right

figure.)

It is recommended to attach the cable covers to protect the

terminal area from dust when hanging the projector from the

ceiling. Please connect the covers to the projector with the

provided straps to prevent the covers from falling off.

Follow these steps to attach the support cover and cable cover.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 91 92

Pas de commentaire

Sanyo PDG-DET100L Manuel du propriétaire Page 22