Sanyo PLC HF15000L Manuel d'utilisateur télécharger pdf (Page 16)

When controlling several projectors from each remote control at the same time, you can assign a remote

control code (Code 1 - Code 8) to individual projectors and remote controls to prevent remote control

interference. Assign the same code the you specified for the projector to the remote control. See “Remote

Control” on page 62 for assigning a remote control code to the projector. Follow the procedures below to select

the assigned code.

Remote Control Codes

Part Names and Functions

Press and hold the MENU and a number button (1–8)

for more than five seconds to switch between the

codes. To reset it to the default code number (Code 1),

use the button combination of the MENU button and

the 0 number button ( press for 5 seconds).

Number buttons

MENU button

✔Note:

To ensure safe operation, observe the following precautions:

• Do not bend, drop, or expose the remote control to moisture or

heat.

• For cleaning, use a soft dry cloth. Do not apply benzene, thinner,

spray, or any other chemical materials.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 99 100

Pas de commentaire

Sanyo PLC HF15000L Manuel d'utilisateur Page 16