Sanyo PLC HF15000L Manuel d'utilisateur télécharger pdf (Page 77)

This projector uses high-pressure lamps which must be handled carefully and properly.

Improper handling may result in accidents, injury, or create a fire hazard.

l Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no

guarantee of the same lifetime for each lamp. Some lamps may fail or terminate their lifetime in a

shorter period of time than other similar lamps.

l If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator

lights up, replace the lamp with a new one after the lamps have cooled down. (Follow carefully the

instructions in the Lamp Replacement section of this manual.) Continuous use of the lamp with the

LAMP REPLACE indicator lighted may increase the risk of lamp explosion.

l Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its

lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in

which the projector and lamp are being used.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.

If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an

authorized service center for a checkup of the unit and replacement of the lamp. Additionally, check

carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out

from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one

should check the inside of the projector except those who are authorized trained technicians and who

are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those

who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken

glass.

LAMP HANDLING PRECAUTIONS

Maintenance and Care

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following

information to the dealer.

l Model No. of your projector: PLC-HF15000L

l Replacement Lamp Type No.: POA-LMP147

(Service Parts No. 610 350 9051)

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 99 100

Pas de commentaire

Sanyo PLC HF15000L Manuel d'utilisateur Page 77