Sanyo PLC HF15000L Manuel d'utilisateur télécharger pdf (Page 82)

WARNING:

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If problems still persist after following all operating instructions, contact the dealer where you purchased the projector

or the service center. Specify the model number and explain about the problem. We will advise you how to obtain

service.

Appendix

The shutter does not

work.

– Check “Protection” or “Release Key” of the shutter function. (See page 66)

The power is turned off

automatically.

– Power management function runs by initial setting. Check “SETTING” section on page

63.

– When the filter replacement icon keeps appearing on the screen at turning on the

projector for some time and no action is taken to replace the filter, the projector will

be automatically shut down in 3 minutes after turning on to protect the projector. (See

pages 68, 88)

– Do not cover the ventilation slots on the projector. (See pages 4, 6)

– Projector may be used in high ambient temperature environment. Make sure the

temperature is not out of Operating Temperature (41˚F–104˚F [5˚C–40˚C]). (See page 92)

You cannot operate with

the side control.

– The side control is not available If the side control is locked at “Key lock” under

“Security” of SETTING section. Please check “SETTING” section on page 64.

The Remote Control does

not work.

– Check the batteries.

– Check if the RC sensor is set properly. (See page 63)

– Make sure no obstruction is between the projector and remote control.

– Make sure you are not too far from the projector when using the remote control.

Maximum operating range is 16.4’ (5m).

– Make sure that the remote control code conforms to the projector’s code.

(See page 62.)

– Check if the ON/ OFF switch on the remote control is set to ON.

– Unlock the Key lock function for the remote control. (See page 64)

– Wireless remote control does not work when the remote control cable is connected to

the projector. (See page 15)

Indicators blink or light.

– Check the status of the projector with referring to “ INDICATORS AND PROJECTOR

CONDITION” on pages 86-88.

appears on the screen

– Your operation is invalid. Operate correctly.

Unable to unlock the Logo

PIN code lock, Security

key lock or Security PIN

code lock.

– Contact the dealer where you purchased the projector or the service center.

Forget the Logo PIN code

or Security PIN code.

– Contact the dealer where you purchased the projector or the service center.

When brightness (Current

value) continuously

goes down to a certain

rate from Target value in

Constant mode.

– Check the lamp status and replace the lamp, or decrease Target value in Constant

mode.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Sanyo PLC HF15000L Manuel d'utilisateur Page 82

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Sanyo PLC HF15000L